Encoding error Air Panasonic
To facilitate the repair and sửa điều hòa conditioner repair service listed Air conditioning fault code table Panasonic as follows;




Applies to all models Inverter 2007 (GKH), 2008 (HKH), 2009 (JKH), 2010 (KKH).


How to query the error code on the remote air conditioning:
1. Use a toothpick holding down the CHECK button for about 5 seconds, until the screen is seal - -
2. Aim the remote control of air conditioning failure, press and hold TIMER button, each press of the button the display will show the error code sequence and the POWER indicator light on the refrigerator will flash once to confirm the signal.
3. When the POWER indicator light and air conditioner beeps continuously for 4 seconds, error codes appearing on the screen was the fault of air conditioning are met.
4. Mode query error code will disconnect when holding down the CHECK button for 5 seconds or automatically end after 20 seconds if you do not perform more operations.
5. Temporarily remove errors in the freezer by short supply or press the RESET AC and Refrigeration operation to check the error does not appear.
Error code: 00H
- No abnormal findings
Error code: 11H
- Error data path between the indoor unit and outdoor unit.
Error code: 12H
- Other error between outdoor unit capacity and cooler.
Error code: 14H
- Error room temperature sensor
Error code: 15H
- Error temperature sensor compressor.
Error code: 16 H
- Compressor load current is too low.
Error codes: 19h
- Error in the fan block.
Error codes: 23h
- Error evaporator temperature sensor
Error code: 25H
- E-ion circuit fault
Error code: 27H
- Error outdoor temperature sensor.
Error code: 28H
- Error hot temperature sensor platforms.
Error code: 30H
- Error temperature sensor tube out of the compressor.
Error code: 33H
- Error connecting blocks inside and outside.
Error codes: 38h
- Error blocks in and out asynchronously.
Error code: 58H
- Error circuit PATROL
Error code: 59H
- Error circuit ECO PATROL
Error codes: 97h
- Error Outdoor fan
Error codes: 97h
- Cooler temperatures too high (heating mode)
Error codes: 99h
- Evaporator temperature is too low. (Freezing)
Error code: 11F
- Error mode switch cooling / warming Sui
Error code: 90F
- Error on the compressor PFC circuit.
Error code: 91F
- Error loading compressor flow too low.
Error code: 93F
- Error-speed rotary compressor.
Error code: 95F
- High temperature hot rig.
Error code: 96F
- The heat capacity of the compressor transistor (IPM)
Error code: 97F
- Temperature too high compressor.
Error code: 98F
- Series compressor load is too high.
Error code: 99F
- DC output pulse compressor is too high